Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 21 February 2019, 07:47:30 am

Login with username, password and session length

Visit the Official Endian Bug tracker  HERE
13872 Posts in 4220 Topics by 5889 Members
Latest Member: jonasgribas
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  VLAN Configuration
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: VLAN Configuration  (Read 1693 times)
Jr. Member
Offline Offline

Posts: 1

« on: Tuesday 05 December 2017, 02:24:22 pm »

I have an endian firewall installed within a virtual machine. The virtual machine has two physical interfaces. Is it possible to make the endian firewall a router on a stick configuration? Is it possible to assign multiple VLANs to the same interface and have that interface connect to a downstream managed switch with VLANs assigned to the ports? So even though different VLAN traffic is passing over the same link, it cannot communicate with other VLAN traffic unless it travels to the endian firewall/router and the router forwards it onto another VLAN interface.

I guess I could create multiple virtual network adapters and tie them to the same internal virtual switch. This would essentially have the same effect, but I would like the virtual interfaces to be created within the firewall rather than at the virtual hardware level. Any ideas?
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.167 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com