Welcome, Guest. Please login or register.
Did you miss your activation email?
October 19, 2017, 02:37:04 PM

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
13516 Posts in 4150 Topics by 5112 Members
Latest Member: jendMofe
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  VPN Support
| | |-+  IPsec/NAT not working
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: IPsec/NAT not working  (Read 67 times)
Jr. Member
Offline Offline

Posts: 1

« on: October 12, 2017, 06:32:16 PM »


I'm running Endian Community 3.0 and I'm having trouble connecting to another net over IPsec.
Well, the tunnel is actually connecting but I'm not able to ping anything on the other side. I'm assuming that there's a problem with the NAT I configured. The nets that should be connected are (my side) and
I configured the following NAT rule:

Source NAT
Source:        Network/IP
Destination:  Network/IP
Service/Port: ANY/ANY
NAT to source address Auto

Maybe someone can point me to where I'm wrong? Help is much appreciated.

Thanks in advance.
Full Member
Offline Offline

Posts: 42

« Reply #1 on: October 16, 2017, 06:12:14 PM »

why you have setup this Source NAT rule?  for the IPSec tunnel is not necessary.
If you cannot reach the other side maybe the tunnel is not properly established, could you please try from SSH to run the following command in order to see if the IPSec tunnel is up?

ipsec statusall

Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.066 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com