Welcome, Guest. Please login or register.
Did you miss your activation email?
November 23, 2017, 01:37:12 AM

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
13543 Posts in 4160 Topics by 5268 Members
Latest Member: Khmart
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  EFW 3.2.2 not booting after install
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: EFW 3.2.2 not booting after install  (Read 939 times)
jesus.beltran
Jr. Member
*
Offline Offline

Posts: 2


« on: April 05, 2017, 02:44:10 AM »

Hi,

I'm setting up a new equipment with EFW 3.2.2. Installation goes fine, but as soon as it is completed and the system reboots from HDD, it goes to a black screen with blinking cursor. Nothing else happens. I already tried EFW 3.2.2 and 3.2.1 with the same result. Even swapped hard drives.

System Specs are:

  Gigabyte GA-H81M-H motherboard
  Pentium G3260 LGA1150 processor
  4GB RAM
  Toshiba SATA-3 500Gb Hard Drive

I've disabled the serial port console option at the installation, so I guess this isn't the issue.

Anyone has had the same problem before? Any hints?
Logged
jesus.beltran
Jr. Member
*
Offline Offline

Posts: 2


« Reply #1 on: April 05, 2017, 04:04:57 AM »

Ok figured this one out. Had to turn off AHCI for SATA on the board's BIOS. That did the trick.
Logged
marziano
Jr. Member
*
Offline Offline

Posts: 1


« Reply #2 on: November 03, 2017, 09:16:30 PM »

Ok figured this one out. Had to turn off AHCI for SATA on the board's BIOS. That did the trick.

Ok, this worked for me too. But what if you want to use a solid state drive? You need AHCI for TRIM to work.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.06 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com