Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 29 March 2024, 10:30:24 pm

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14247 Posts in 4376 Topics by 6490 Members
Latest Member: maquino
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Hardware Support
| | |-+  changing NIC
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: changing NIC  (Read 7671 times)
ollenotna
Jr. Member
*
Offline Offline

Posts: 3


« on: Monday 19 October 2015, 05:39:45 am »

I had to transfer my disk with endian 2.5.1 on a new computer, then with new network cards.

Now, clearly the network cards (only red and green) were eth2 and eth3.

I then edited /etc/businfotab changing eth2-eth3 to eth0-eth1.

On restart with ifconfig I see that eth1 is properly configured with the IP address of the external network (red), while the eth0 is not configured.

Yet in /var/efw/ethernet/settings I see:

GREEN_ADDRESS = 192.168.0.2
GREEN_BROADCAST = 192.168.0.255
GREEN_IPS = 192.168.0.2 / 24
GREEN_NETADDRESS = 192.168.0.0

there is also
GREEN_DEV = br0

and in /var/efw/ethernet/br0 I see:

eth0

In short, eth0 should be configured.

I try  netwizard but I get an invalid command mssage (I assume it is for  3.0 endian)
and I do not know how to change the card's via console, as I can not use the web interface.

what shall I do?

other option:
reinstall from scratch upgrading to endian 3
but how to save the configurations of the existing proxy and transfer them to the new installation, all from the console?

TIA
Antonello
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.031 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com